产品
Low Power 收发器 with 以太网 - VHF / UHF (20-90)
The 20-90 is a simple to configure POCSAG paging transceiver with a high sensitivity receiver combined with a 100mW transmitter. It operates over the frequency range of 142-175MHz (VHF variant) or 440 479MHz (UHF variant) decoding and encoding 512, 1200或2400波特, alphanumeric or numeric messages.
The 20-90 supports multiple message queueing and will queue up to four 73-character messages or more smaller messages.
The 20-90 Can be controlled via an RS232 serial interface or TCP/IP to provide numeric, alphanumeric and tone only POCSAG encoding.
The product supports full batching of serially queued input messages and can be configured to automatically respond with checksum information of the last received message.
An intelligent self-adjusting channel busy check prevents message collision or corruption.
The receiver is supplied with clean contacts rated at 1A 24V DC operation. LEDs indicate receiver operation and status.
Virtual outputs can be used to remotely trigger input or periodic messages and provide a mechanism to acknowledge reception of messages. It can transmit the received signal strength of the last received message allowing the receiver positioning and system health to be monitored.
| 频率范围 | 甚高频:140 - 176MHz UHF: 420 - 480MHz |
| 频率选择 | 用户可配置的 |
| 传输能量 | 10mW, 20mW, 50mW or 100mW |
| 发射占空比 | 100% |
| 通道宽度 | 6.25khz, 12.5千赫或25千赫 |
| 偏差 | ±1.0 khz,±2.3kHz或±4.5 khz |
| 调制 | GFSK with NRZ data (POCSAG) |
| 空中波特率 | 512, 1200, 2400 |
| 接收机灵敏度 | - 123dbm, 512波特 - 118dbm, 2400波特 |
| 继电器 | Two 继电器 on RJ45 connector; one SPDT, one SPST |
| 可定义I / O | Five I/O pins user configurable as input or output |
| 明渠输出 | Up to two 500mA open drain outputs with resettable fuses on RJ45 Up to three 5mA current limited open drain outputs on RJ12 |
| 输入 | Up to five active low inputs on open drain output pins |
| 串行端口 | RS-232 on RJ12 connector. 9600 baud, no parity, 8-bits, 1-stopbit |
| 数据接口 | RS-232 (with adaptor) and 以太网 |
| 串行协议 | Salcom, Scope, TNPP v3.8 |
| 配置软件 | Salcom 配置工具 (Sacoto) |
| 射频连接器 | 50ΩSMA |
| 电源连接器 | DC power pluggable terminal block (provided) |
| 电力供应 | +13.8V typical (10 to 15 VDC range) |
| 电力消耗 | 马备用:45 传输:90马 以太网: +35mA when connected to 以太网 继电器: +20mA per energized relay |
| 工作温度 | -10ºC to +50ºC (+14ºF to +122ºF) |
| Environmental Protection | Not suitable for unprotected outdoor use. Must be protected from adverse environmental conditions. |
| 指标 | 电源指示灯(绿色) • Slow Flashing = Normal Operation • Fast Flashing = low battery TX/Busy LED(红色) • Flashing fast = Transmitting • Solid on = Chanel busy |
| 重量 | 190g |
| 外壳尺寸 | 130mm x 68mm x 31mm (W x D x H) |
| 外壳材料 | 挤压铝 |
| 颜色 | Bright silver anodised aluminium |
| 类型的审批 | 通过4769.1:2000 + Amendment 1:2002 (RF) En 300-224 v2.1.0 (RF), EN 301-489-2 V2.1.0 (EMC) EN 60950-1:2006 (Safety) FCC CFR47 Part 90 (RF), Part 2 (RF), Part 15 (EMC), Part 1 (Safety) |
The 20-90 Can be controlled via an RS232 serial interface or TCP/IP to provide numeric, alphanumeric and tone only POCSAG encoding.
The product supports full batching of serially queued input messages and can be configured to automatically respond with checksum information of the last received message.
An intelligent self-adjusting channel busy check prevents message collision or corruption.
The receiver is supplied with clean contacts rated at 1A 24V DC operation. LEDs indicate receiver operation and status.
Virtual outputs can be used to remotely trigger input or periodic messages and provide a mechanism to acknowledge reception of messages. It can transmit the received signal strength of the last received message allowing the receiver positioning and system health to be monitored.
| 频率范围 | 甚高频:140 - 176MHz UHF: 420 - 480MHz |
| 频率选择 | 用户可配置的 |
| 传输能量 | 10mW, 20mW, 50mW or 100mW |
| 发射占空比 | 100% |
| 通道宽度 | 6.25khz, 12.5千赫或25千赫 |
| 偏差 | ±1.0 khz,±2.3kHz或±4.5 khz |
| 调制 | GFSK with NRZ data (POCSAG) |
| 空中波特率 | 512, 1200, 2400 |
| 接收机灵敏度 | - 123dbm, 512波特 - 118dbm, 2400波特 |
| 继电器 | Two 继电器 on RJ45 connector; one SPDT, one SPST |
| 可定义I / O | Five I/O pins user configurable as input or output |
| 明渠输出 | Up to two 500mA open drain outputs with resettable fuses on RJ45 Up to three 5mA current limited open drain outputs on RJ12 |
| 输入 | Up to five active low inputs on open drain output pins |
| 串行端口 | RS-232 on RJ12 connector. 9600 baud, no parity, 8-bits, 1-stopbit |
| 数据接口 | RS-232 (with adaptor) and 以太网 |
| 串行协议 | Salcom, Scope, TNPP v3.8 |
| 配置软件 | Salcom 配置工具 (Sacoto) |
| 射频连接器 | 50ΩSMA |
| 电源连接器 | DC power pluggable terminal block (provided) |
| 电力供应 | +13.8V typical (10 to 15 VDC range) |
| 电力消耗 | 马备用:45 传输:90马 以太网: +35mA when connected to 以太网 继电器: +20mA per energized relay |
| 工作温度 | -10ºC to +50ºC (+14ºF to +122ºF) |
| Environmental Protection | Not suitable for unprotected outdoor use. Must be protected from adverse environmental conditions. |
| 指标 | 电源指示灯(绿色) • Slow Flashing = Normal Operation • Fast Flashing = low battery TX/Busy LED(红色) • Flashing fast = Transmitting • Solid on = Chanel busy |
| 重量 | 190g |
| 外壳尺寸 | 130mm x 68mm x 31mm (W x D x H) |
| 外壳材料 | 挤压铝 |
| 颜色 | Bright silver anodised aluminium |
| 类型的审批 | 通过4769.1:2000 + Amendment 1:2002 (RF) En 300-224 v2.1.0 (RF), EN 301-489-2 V2.1.0 (EMC) EN 60950-1:2006 (Safety) FCC CFR47 Part 90 (RF), Part 2 (RF), Part 15 (EMC), Part 1 (Safety) |
